Hardware Design and Implementation of a Lightweight Saber Algorithm Based on DRC Method

With the development of quantum computers, the security of classical cryptosystems is seriously threatened, and the Saber algorithm has become one of the potential candidates for post-quantum cryptosystems (PQCs). To address the problems of long delay and the high power consumption of Saber algorithm hardware implementation, a lightweight Saber algorithm hardware design scheme based on the joint optimization of data readout and clock (DRC) was proposed. Firstly, an analysis was carried out on the hardware architecture, timing overhead and power consumption distribution of the Saber algorithm, and the key circuits that limit the performance of the algorithm were identified; secondly, a dual-port SRAM parallel reading method was adopted to improve the data reading efficiency and reduce the timing overhead of double data reading in the multiplier module. Then, a clock gating technology was used to reduce the dynamic flipping probability of internal registers and reduce the hardware power consumption of the Saber algorithm; finally, data reading and clock gating were jointly optimized to design a high-speed and low-power Saber algorithm hardware IP core. Lightweight IP cores were integrated into RISC-V SoC systems via APB bus in a TSMC 65 nm process to complete the digital back-end design. The experimental results show an IP core area of 0.99 mm2 and power consumption of 8.49 mW, which is 33% lower than that reported in the related literature. Under 72 MHz & 1 V operating conditions, the number of clock cycles for the Saber algorithm’s key generation, encryption and decryption are 3315, 9204 and 1420, respectively.